APCSMART-OLD(8) =============== NAME ---- apcsmart-old - Driver for American Power Conversion Smart Protocol UPS equipment SYNOPSIS -------- *apcsmart-old* -h *apcsmart-old* -a 'UPS_NAME' ['OPTIONS'] NOTE: This man page only documents the hardware-specific features of the apcsmart-old driver. For information about the core driver, see linkman:nutupsdrv[8]. SUPPORTED HARDWARE ------------------ apcsmart-old should recognize all recent APC models that use a serial protocol at 2400 bps. This is primarily the Smart-UPS, Matrix-UPS and Back-UPS Pro lines. The driver attempts to support every bell and whistle of the APC reporting interface, whether or not this is strictly sensible. Some older hardware may only report a handful of variables. This is usually not a bug--they just don't support anything else. CABLING ------- This driver expects to see a 940-0024C cable or a clone by default. You can switch to the 940-0095B dual-mode cable support with the `cable=` definition described below. If your 940-0024C cable is broken or missing, use this diagram to build a clone: http://www.networkupstools.org/cables/940-0024C.jpg EXTRA ARGUMENTS --------------- This driver supports the following optional settings in the linkman:ups.conf[5]: *cable=940-0095B*:: Configure the serial port for the APC 940-0095B dual-mode cable. *sdtype=*'num':: Use shutdown type 'num', according to this table: 0;; soft shutdown or powerdown, depending on battery status 1;; soft shutdown followed by powerdown 2;; instant power off 3;; power off with grace period 4;; "force OB" hack method for CS 350 Modes 0 and 1 will power up the load when power returns. Modes 2 and 3 will keep the load turned off when the power returns. Mode 4 exploits an oddity in the CS 350 models since they only seem to support the S command, but then only when running on battery. As a result, the driver will force the UPS to go on battery if necessary before sending the shutdown command. This ensures that the load gets reset. BUGS ---- Some older APC UPS models return bogus data in the status register during a front panel test. This is usually detected and discarded, but some other unexpected values have occasionally slipped through. APC UPS models with both USB and serial ports require a power cycle when switching from USB communication to serial, and perhaps vice versa. AUTHOR ------ Nigel Metheringham (drawing heavily on the original apcsmart driver by Russell Kroll). This driver was called newapc for a time and was renamed in the 1.5 series. In 2.6.2 the driver was renamed to apcsmart-old, being superseded by updated version with new features. SEE ALSO -------- The core driver: ~~~~~~~~~~~~~~~~ linkman:nutupsdrv[8] Internet resources: ~~~~~~~~~~~~~~~~~~~ The NUT (Network UPS Tools) home page: http://www.networkupstools.org/