nut-debian/drivers/tripplite.h

59 lines
2.4 KiB
C
Raw Normal View History

2010-03-26 01:20:59 +02:00
/* tripplite.h - model specific routines for Tripp Lite SmartUPS models
(tested with:
"SMART 700" [on back -- "SmartPro UPS" on front], "SMART700SER")
tripplite.c was derived from Russell Kroll's bestups.c by Rik Faith.
Copyright (C) 1999 Russell Kroll <rkroll@exploits.org>
Copyright (C) 2001 Rickard E. (Rik) Faith <faith@alephnull.com>
Copyright (C) 2004,2008 Nicholas J. Kain <nicholas@kain.us>
This program is free software; you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation; either version 2 of the License, or
(at your option) any later version.
This program is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
GNU General Public License for more details.
You should have received a copy of the GNU General Public License
along with this program; if not, write to the Free Software
Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA
*/
#define ENDCHAR '\n' /* replies end with CR LF -- use LF to end */
#define IGNCHAR '\r' /* ignore CR */
#define MAXTRIES 3 /* max number of times we try to detect ups */
#define SER_WAIT_SEC 1 /* allow 1.0 sec for ser_get calls */
#define SER_WAIT_USEC 0
#define DEFAULT_OFFDELAY 64 /* seconds (max 0xFF) */
#define DEFAULT_STARTDELAY 60 /* seconds (max 0xFFFFFF) */
#define DEFAULT_BOOTDELAY 64 /* seconds (max 0xFF) */
/* Sometimes the UPS seems to return bad data, so we range check it. */
#define INVOLT_MAX 270
#define INVOLT_MIN 0
#define FREQ_MAX 80.0
#define FREQ_MIN 30.0
#define TEMP_MAX 100
#define TEMP_MIN 0
#define LOAD_MAX 100
#define LOAD_MIN 0
/* We calculate battery charge (q) as a function of voltage (V).
* It seems that this function probably varies by firmware revision or
* UPS model - the Windows monitoring software gives different q for a
* given V than the old open source Tripp Lite monitoring software.
*
* The discharge curve should be the same for any given battery chemistry,
* so it should only be necessary to specify the minimum and maximum
* voltages likely to be seen in operation.
*/
/* Interval notation for Q% = 10% <= [minV, maxV] <= 100% */
#define MAX_VOLT 13.4 /* Max battery voltage (100%) */
#define MIN_VOLT 11.0 /* Min battery voltage (10%) */